TRIDENT BODY GRILL & LIGHTS

ROCK PIRATES RC TRIDENT BODY GRILL AND HEADLIGHTS SET.  

The same super bright LED lights (Powered by MY TRICK RC) that we use in our Locker Lights!

Special Features:

Very scale looking and easy to install design. 

2 very bright preinstalled LED headlights with male plug to plug directly into the second port of the RPRC Locker Lights Control Module. 

Flush mounting grill that matches the Trident Body perfectly. 

Hardware Included (two screws). 

Instructions

So simple even a humble pirate can do it :)

NOTE: Don't paint over the headlights on your Trident Body, these will be the lenses for your headlights. Use the masking kit provided with your Trident Body to mask the headlights before painting. 

Locate the two turn signal lamp circles molded into the grill of the Trident Body. Use a Lexan body hole reamer and ream two holes dead center in both lamp circles. Make the holes just big enough for the posts that are molded into the back side of the grill to pass through. Make sure the grill is level and centered.

On the backside of the body, install the inner grill plate which retains the lights and wiring. Slide it over the two grill posts (make sure it's right side up) and install the two mounting screws provided in the kit. tighten the screws until they are snug and the whole assembly is flush and secure. 

Route your wires towards the center of the body away from your tires and any other moving parts. You can secure the wires to the inside of the body with tape or dabs of Household Goop. 

Plug the Grill wires into the second port of you Locker Lights Controller Module. 

Thats all, you're done! 

Popular With This Item:

RPRC Trident Body

RPRC Locker Lights